Not sure this is the absolute best community but it’s what comes to mind.

Was watching this: https://youtu.be/S7dWigI7Soc

Say at the gas pump should I be using tap rather than pin code?#

  • coffeebiscuit@lemmy.world
    link
    fedilink
    arrow-up
    21
    ·
    5 months ago

    The rfid can work trough fabric. So a shielded wallet is a smart choice. Technically someone can make you pay by tapping your pants with a terminal device. Does this happen allot? No not really. But technically possible and more likely when more people use tap.

    Here there is a maximum amount that can be paid with only contactless payment without a PIN code. If the price is higher a pin prompt will show up automatically (max $25,-) If you pay more things in a short time with the rfid than the pin prompt will eventually show up. So an unlimited amount of low payments isn’t possible. (Do check your bank for these details.) So when you lose your card your account can’t be drained. (Unless you have less than the minimum amount on your account)

    Phones can also be setup as a contactless payment method, and would physically work the same. With the benefits of having a stronger signal, and being locked behind your phone lock (facial recognition or whatever.)

  • karika@lemmy.world
    link
    fedilink
    arrow-up
    19
    arrow-down
    1
    ·
    5 months ago

    Buy a bar of chocolate. Eat the chocolate. Put the tinfoil in your wallet. Works the same. It’s cheaper and tastier

  • root@lemmy.world
    link
    fedilink
    arrow-up
    14
    arrow-down
    1
    ·
    5 months ago

    I’ve seen videos that show having two touch enabled cards next to each other prevents anyone from scanning, since their signals cause interference with one another.

    I came across the video when looking up those RFID blocking cards you can add to a non shielded wallet and they work the same way

  • UnfortunateShort@lemmy.world
    link
    fedilink
    arrow-up
    5
    ·
    5 months ago

    I have a wallet that’s supposedly shielded and it turned out to be useless. Then I got a jammer card as a marketing gimmick. It doesn’t just shield, it creates interferences. The stronger the EM field the better, to some degree. It actually works flawlessly. At least with my smartphone I can’t read any NFC chip near that card.

  • lemonuri@lemmy.ml
    link
    fedilink
    arrow-up
    4
    arrow-down
    4
    ·
    5 months ago

    If you do not need the nfc cabability of your cards, just his them in front of a bright lamp, see where the cables run and cut the card with a scissor. Apply transparent tape over the cut and you have a privacy respecting card again. It’s what I always do as my bank offers no service to disable nfc.